How do I wire the output connector for YC?
| 1 | |
| 2 | C |
| 3 | Y |
| 4 |
Veiw of Connector on back of Adept
How do I wire the output connector for RGB?
| 1 | G |
| 2 | R |
| 3 | B |
| 4 | sync |
Veiw of Connector on back of Adept
How do I wire the output connector for YCrCb?
| 1 | Y |
| 2 | Cr |
| 3 | Cb |
| 4 | sync |
Veiw of Connector on back of Adept
How can I see the menu after a power up from using the test generator?
Press the menu button or do a power on reset
Why when I look at the SDI vector diagram are the lines bending
The selection switch on the back panel needs to be configured for YUV not RGB
How do I can I use the Adept 700WVA as a generator and monitor at the same time?
In the menu select the test function select the required signal (this signal is now being generated out of the output connector) connect from the output connector to the device under test connect the device under test to the correct input of the Adept connect the Adept viewing monitor to the WFM connector this will allow you to view the measurement waveforms (but not the picture)
What is the audio breakout cable colour coding?
White (XLR socket) - AES in
Red (XLR socket) - Analog in Left
Green (XLR socket) - Analog in Right
Red (XLR pin) - Analog out Left
Red (XLR pin) - Analog out Right
| 1.5 kilo |
in cm
Length:- 32
Width:- 23
Height:- 5